The Table chart below gives typical mechanical characteristics for selected properties. For all critical applications, verify to the applicable industry or requisite material / steel standard. Custom Steel Processing, Steel Edging, Hardened and Tempered. Blue Blade Steel offers high quality alloy steel AISI/SAE 6150, 5160, 4140, 4142, 4150, and 10B38 Strip Coil to name a few. Materials can be hardened and tempered to meet your specific application requirements. Aug 16, 2020.
Chemical Analysis | |
---|---|
C% | Carbon 0.48 – 0.53 |
Mn% | Manganese 0.70 – 0.90 max |
P% | Phosphorus 0.040 max |
S% | Sulfur 0.040 max |
Si% | Silicon 0.20 – 0.35 |
Cr% | Chromium 0.70 – 0.90 |
5160/6150 spring steel 5160 Spring Steel is a low Chromium alloy steel, with around 0.7 Chromium - which is not enough to make it stainless (which requires a minimum of 13% Chromium) - but combined with a small amount of silicon (0.2%) results in an extremely tough and durable sword and is favored by some of the best custom sword makers. All, I am looking for the pros and cons comparing 52CrMoV4 1.7701, 5160, and 6150 for spring application. Currently have a requirement for 5,000 minimum cycle l 52CrMoV4 1.7701 vs 5160 vs 6150 for spring material - Material engineering general discussion - Eng-Tips. Skyrim for mac free zip. Cat d399 parts manual.
6150 Vs 5160 Steel Reviews
General characteristics of Alloy Steel 5150
Vms 001 driver for mac. Alloy 5150 is a medium-carbon, chromium steel with good strength, toughness and hardenability
Applications
6150 Vs 5160 Steel For Sale
This alloy is used in the production of fprged components that are subjected to normal stresses for automotive and general engineering.
Forging
This alloy would be forged between 2150 and 1600ºF ( 1175 and 870ºC.) The alloy should be slow cooled after forging or transferred to a furnace around the ‘finishing’ temperature.
Heat treatment
Annealing:The microstructure for this alloy to give optimum machinability is one of course lamellar pearlite to coarse spheroidite. This might be obtained by austenitizing at 1380ºF (750ºC) followed by an iso anneal at 1250ºF (680ºC.)
Normalizing: A nominal normalizing temperature for this alloy is 1600ºF (870ºC.) This treatment is followed by air cooling
Hardening: Austenitize at 1475-1550ºF (800-845) and oil quench for small, intricate sections and water quench for large, simple sections.
Tempering: from 1000-1250ºF(540-680ºC) as per required properties.
Machinability: This alloy is readily machined from a coarse pearlite to a coarse spheroidite microstructure.
Weldability: The alloy may be welded but must be preheated and if possible the preheat should be maintained during welding. Welding should be carried out in the annealed condition, not on hardened and tempered material.
6150 Vs 5160 Steel Vs
5160 Vs 6150 Steel
To Send a Request for Quote, please Click Here, or call 1.973.276.5000 or 1.800.600.9290 or fax 1.973.276.5050.